Emulators EURO6 Disable system:
每 blue system (Fully)
每 blue NOX sensor
每 DPF system
每 DPF temperature sensors
每 DPF regeneration
After installing Euro6 emulator, you can remove:
每 DPF sensors 每 YES
每 NOx sensor 每 YES (only in DAF don＊t remove first NOx sensor !!!)
每 temp. sensor (s) 每 YES
每 pump 每 YES
每 level sensor 每 YES
每 ECU 每 YES
Kindly note: It is possible to disable system by installing an emulator (programmable device) into the vehicle. You can switch it on/off anytime.
EURO6 Emulators using guide:
Emulator Man Euro 6 does not need to be learned. You install emulator under the metal cover of Pump on the right side behind the cab, and disconnect plug from Pump and connect emulator.
Next, you need to remove the fuses:
F894(Multisensor In tank)
F738 (+30 Signal of pump)
F1084 (NOx sensor Upstream)
Fuse F737 is now fuse of emulator.
Fuse F1109 is the fuse of NOx sensor Downstream and A1191 mufler temperature sensor. This sensor needs to work correctly for DPF regenaration.
Finally, you need to remove Power from NOx downstream sensor. There are two ways options, one is to cut pin 1 in NOx sensor plug, the other way (better) is toremove pin 10 in X3212 plug. This plug is visible on rear of engine on the right side. This is TE plug (16 pin) wiht yellow key.
Package List: |
obdcartool
German
Spanish
French
Italian
Portuguese
Japanese
Korean
Arabic
Russian
Chinese